Starter Vape Kit seasonal demand planning overview

How the price is actually built

We work with private label sellers who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.

The cheapest way to lower your cost per unit is usually to remove a SKU, not to negotiate a discount. Fewer lines means larger runs, fewer changeovers and a better price at the same quality.

Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.

Getting the carton there intact

Damage in transit is nearly always a packing decision, not bad luck. Double-walled cartons, internal dividers and a drop-tested configuration cost a little more and save the argument at the other end.

We ship from Shenzhen and Guangzhou: air express for samples and part loads, sea freight for volume. Typical production lead time is 22 working days after artwork approval, plus transit. We quote both routes so you can see the trade-off instead of guessing at it.

Building an assortment that actually turns

Colour range is where assortments quietly die. Six finishes look impressive in a brochure and disastrous on a shelf with 40 cm of space. We recommend two finishes per core SKU and let the trial line carry the novelty.

A practical starting order for private label sellers is 200 units across two or three SKUs, not 200 units of one. That spreads the risk, gives your staff something to compare, and still hits the first price break.

• Reference sample retained from every batch
• Private label files archived for future rebrands
• Standing reorder schedule with a fixed cut-off
• Specification locked in writing before production starts
• Artwork proof plus physical dummy for custom packaging
• Named account contact who has handled the product

What we test before a carton is sealed

Battery safety is not a marketing line. Cells are matched by capacity and internal resistance before assembly, charging boards are checked for cut-off voltage, and any unit that fails the cut-off test never reaches packing.

Cosmetic grading is written down, not argued about. Minor scuffs inside the tolerance band are accepted; anything that would make a customer put the unit back on the shelf is rejected. Your staff should never have to explain a finish defect to a paying customer.

Specification summary

None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.

Frequently asked

Related reading

Tel / WeChat / WhatsApp +86 13711127975  ·  vape@0099933.xyz