Starter Vape Kit lead time glossary guide
Starter Vape Kit is a specification decision before it is a price decision. Get the resistance, the capacity and the packaging right and the price conversation becomes short. Get them wrong and no discount will rescue the order.
Published 04 December 2025 · VapeWholesaleHub · Reading time 8 min
Compliance without the last-minute scramble
We work with private label sellers who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.
Artwork approval is a two stage process: a digital proof for text and layout, then a physical dummy for colour and finish. Skipping the dummy is the single most common cause of a reprint.
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
Choosing the core line
When you compare suppliers for starter vape kit, ask for the last three production dates on the same SKU. If the answers are vague, the specification is not being held and the next batch will not match the sample you approved.
A practical starting order for private label sellers is 500 units across two or three SKUs, not 500 units of one. That spreads the risk, gives your staff something to compare, and still hits the first price break.
Unit price versus landed cost
A landed cost sheet for starter vape kit has five lines: unit price, packaging, freight, duty and the cost of defects. Quoting only the first line is how buyers end up surprised at the fourth.
Unit price breaks usually land at 500, 1000 and 2000 pieces. Between those steps the cost curve flattens, which is why pushing a 200 unit order to 500 often costs less per unit than buyers expect.
- Artwork proof plus physical dummy for custom packaging
- Batch codes traceable from carton back to production date
- Seven-day defect reporting with replace-or-credit
- Document pack prepared per destination market
- Specification locked in writing before production starts
- Consolidated or split shipping, quoted both ways
Quality control, in plain terms
Battery safety is not a marketing line. Cells are matched by capacity and internal resistance before assembly, charging boards are checked for cut-off voltage, and any unit that fails the cut-off test never reaches packing.
11 separate checks run before a carton is sealed: electrical, mechanical, leak, finish and packaging. Anything outside tolerance is quarantined the same day and reported to you, rather than shipped with a hope and a discount.
Specification summary
| Battery | 350 mAh |
| Pod capacity | 2.5 ml |
| Coil resistance | 0.8 ohm |
| Included | Device, 2 pods, cable |
| Charging | USB-C 5V/1A |
| Packaging | Blister pack |
| Minimum order | 50 units per SKU, mixed cartons allowed |
| Lead time | 30 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
What documents come with a shipment?
Commercial invoice, packing list, and the certificate pack for your market: test reports, declaration of conformity and safety data sheets. We send scans before dispatch so your broker can pre-clear the file.
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 500 units. We would rather you handle the sample than approve a specification from a photograph.
Related reading
Need a quotation on starter vape kits?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz